General How-To Videos
Fuji Temperature Controller – How to Use and Program
How to use and program a Fuju temperature controller.
In this video we show you how to perform a calibration check (Audit) on a transducer that is connected to a Red Lion Process Meter following EPA Method 2 Procedures (an procedure that applies to many isokinetic methods such as Methods 5, 17, 23, 26A, 29, 201A and 202).
Apex Instruments technician Joe Thompson provides a tutorial on what damping is and how to use it when sampling a stack with a digital metering console. Joe also goes in to how to change these settings on your console.
For the XD-502, the procedure is covered from 0:00 to 3:56 of this video. For other consoles such as the XC-53, XC-170, and XC-623, the appropriate procedure is covered from 3:56 to 5:57 of this video.
Red Lion Scaling Factor Input
Apex Instruments technician Joe Thompson provides a tutorial on how access and input the scaling factor on your Red Lion totalizer.
Uploading Firmware to Digital Metering Consoles
Apex Instruments technician Joe Thompson provides a tutorial on how access and upload firmware to a digital metering console. This procedure is used in E170 electronics package consoles such as the XC-53, XC-170 and XC-623. This procedure does not apply to the XD-502 console.
Backside Leak Check on Digital Method 5 Metering Consoles
Apex Instruments technician Joe Thompson provides a tutorial on how to perform a backside leak check on a digital Method 5 metering console. This procedure is applicable for consoles such as the XD-502 and XC-53.
Apex Instruments technician Joe Thompson provides a tutorial on when it is necessary to use a booster pump and how to use a booster pump with a digital metering console.
Apex Instruments technician Joe Thompson provides a tutorial on recognizing when you would need to offset your TC reading. Joe also goes in to how to change the offset on a digital metering console.
Apex Instruments technician Joe Thompson provides a tutorial on how to use a membrane switch to control the functions on a digital metering console.
Apex Instruments technician Joe Thompson provides a tutorial on how to use the AUX switch on metering consoles.
Changing Units on Digital Metering Consoles
Apex Instruments technician Joe Thompson provides a tutorial on how to change the units on a digital metering console using the user menu.
Apex Instruments technician Joe Thompson provides a tutorial on how to use the coarse and fine valves on metering consoles.
Apex Instruments technician Joe Thompson provides a demonstration of what damping is and how it is used in our digital metering consoles.
